Teacup Pincushion Inspiration

When I am on Pinterest, I often look at the DIY tab for inspiration. I can’t take credit for all my different diys, often I see them and want to share my experience with them with you. The blog where I found this diy can be found here.

I found a great teacup at the thrift store, once again, for $2! If you want a teacup that has its own plate, you can use that too. Antique stores are guaranteed to have tea cups, but you will pay at least $10 to $15 each.

20150729_202806

This is my teacup 🙂 It has a very wide cup, so it can hold lots of pins in the cushion. Here are my steps:

1. Pick out a favorite fabric and cut a circle out of it. You should only need a fat quarter of it. I did not measure my circle precisely, I just winged it with scissors. The first circle I cut out was too small, but I made a second circle for the cushion that was perfect.

2. Run a threaded needle with stitching all around the edge of the fabric circle. It’s a simple in and out stitch. The stitching is shown in the picture below, but the thread is white, and may be a bit difficult to see.

20150729_204757 20150729_204755

 

4. Pull the needle tight, so that the stitches come together to form a tight bunch. Make a knot at this point to keep the stitching pulled tight for when you stuff it.

5. Stuff that thing to bursting! Be careful when stuffing to know put too much strain on the thread opening. I found that just using one finger worked best.

6. If you would like, to keep it in place easier, but some hot glue around the bottom of the pincushion so it keeps it’s place in your teacup. Then, push the cushion into place in your cup.

20150729_211633

Enjoy!

20150729_212028

 

XOXO…PB

Leave a Reply